Atlanta & metro
Laser cleaning in Atlanta.
The crew lives here.
Three of our four operators are based in Atlanta. Nobody is driving in from another state to quote your job, and nothing gets crated up and shipped out — the laser comes to your site, anywhere in the metro.
Atlanta · GA On site, not a shop Chemical-free Non-abrasive Designated LSO
Who shows up
A local crew,
not a franchise map.
Laser Resurfacing Technologies is based in Atlanta, Georgia. Steve Casagrande, Amber Casagrande and Angel Rivera all work out of the metro; Jimmy Stout covers Birmingham. When you call, you are talking to the people who will be standing in front of your material.
Every job is led by a designated Laser Safety Officer, working to written procedures under ANSI Z136 — the standards OSHA points to. On an occupied site, in a live plant, that is the difference between a demonstration and a controlled operation.
- Based inAtlanta, Georgia
- Operators herethree of four
- Where we workyour site, not ours
Around the metro
What the calls
are actually about.
Atlanta is fabrication shops, warehouse and plant maintenance, a rail and freight spine, and a lot of old brick and stone. The same handheld head covers all of it — what changes is the setting, not the method.
- Fabrication & machine shops Mill scale, rust and weld spatter off stock and fixtures. Tables, jigs and vacuum beds cleaned in place instead of being pulled out of production and sent away.
- Plant & facility maintenance Paint, oil, coatings and buildup taken off equipment in critical or confined areas, on a schedule that fits your downtime rather than dictating it.
- Weld & inspection prep Coating and corrosion off the joint and the inch around it, without a tool touching the weld — so nothing is smeared over what the inspection is looking for. The full argument is here.
- Rail & transport Coated shells and confined interiors, cleaned from the inside where there is no practical way to build blast containment and then recover the media back out.
- Brick, stone & historic masonry Soiling and old coatings lifted off sensitive material with no grit against the face, no chemical in the pores and no pressure on the detail. Parameters matched to the material and proven on a test area first.
On our own material
Watch it, then
watch it on yours.
Nine recorded jobs — inside a rail tank car, rust off a steel vacuum bed, coating off a tank car shell, and six shop demonstrations on aluminum, steel and timber. Nothing loads until you press play.
-
01Rust cleaned off a steel vacuum bed -
02Surface rust off structural angle
How a job runs
Tell us the material.
Then the contaminant.
Those two answers set the parameters, and the parameters are set before the job runs rather than during it. We prove them on a test area on your own stock before anything else is touched.
- Mobile across metro Atlanta
- One-time or scheduled
- Confined and hard-to-reach
- No blast media to recover
- No solvent to contain
- Test area before the job
Book a demo
We will bring it
to your shop.
Tell us the surface and what is on it, and we will bring a mobile demo to your location in metro Atlanta and run it on your own material while you watch.